Router#
setup
---
System Configuration Dialog ---
Continue
with configuration dialog? [yes/no]: y
At
any point you may enter a question mark '?' for help. Use ctrl-c to
abort configuration dialog at any prompt. Default settings are in square
brackets '[]'.
Basic
management setup configures only enough connectivity for management of
the system, extended setup will ask you to configure each interface on
the system
Would
you like to enter basic management setup? [yes/no]: y
Configuring
global parameters:
Enter
host name [Router]: Chicago
The
enable secret is a password used to protect access to privileged EXEC
and configuration modes. This password, after entered, becomes encrypted
in the configuration.
Enter
enable secret [<Use current secret>]: secret
The
enable password is used when you do not specify an enable secret
password, with some older software versions, and some boot images.
Enter
enable password [password]: enable
The
virtual terminal password is used to protect access to the router over a
network interface. Enter virtual terminal password: cisco Configure SNMP
Network Management? [no]: n
Current
interface summary
Interface
IP-Address OK? Method Status Protocol
BRI0
unassigned YES unset administratively down
down
BRI0:1
unassigned YES unset administratively down
down
BRI0:2
unassigned YES unset administratively down
down
Ethernet0
unassigned YES unset administratively down
down
Enter
interface name used to connect to the management network from the above
interface summary: Ethernet0
Configuring
interface Ethernet0:
Configure
IP on this interface? [no]: y
IP
address for this interface: 192.168.1.1
Subnet
mask for this interface [255.255.255.0] : 255.255.255.0
Class
C network is 192.168.1.0, 24 subnet bits; mask is /24
The
following configuration command script was created:
hostname
Chicago
enable
secret 5 $1$/Hw9/
enable
password enable
line
vty 0 4
password
cisco
no
snmp-server
!
no
ip routing
!
interface
BRI0
shutdown
no
ip address
!
interface
Ethernet0
no
shutdown
ip
address 192.168.1.1 255.255.255.0
!
end
[0]
Go to the IOS command prompt without saving this config.
[1]
Return back to the setup without saving this config.
[2]
Save this configuration to nvram and exit.
Enter
your selection [2]: 2
Building
configuration...
00:04:14:
%LINK-3-UPDOWN: Interface BRI0:1, changed state to down
00:04:14:
%LINK-3-UPDOWN: Interface BRI0:2, changed state to down
00:04:17:
%LINK-3-UPDOWN: Interface Ethernet0, changed state to up
Use
the enabled mode 'configure' command to modify this configuration.
Chicago#